To advance through the codes while the knob is in position 3 press the start/pause button and that will bring up the next stored code. The control will store multiple error codes. That would mean it’s reporting the Lid Lock Broken Error. See the chart below to decipher what error code is being reported according to what LEDS are on.Īs an example using the chart above once you have set the knob to position 3 and let’s say that the following LEDS were lit up ON, WASH and SPIN. If only the ON led is lit up then there are no stored error codes. Once the knob is at position 3 the led status lights will light up according to the error being reported.

The knob positions can be seen in the image below. Once you have entered service mode rotate the knob to position 3. How To Get Error Codes From A GE Laundry Center Washer Dryer Combo

Once all LEDS blink you have successfully entered service mode. Wait 3 seconds and release both buttons and all LEDS will blink. Press START/PAUSE button and FABRIC SOFTENER button at same time while rotating cycle selector to position 6. Rotate washer cycle selector starting at any position except position 6.Ģ. GE Laundry Center Diagnostics Service Mode : How To Enter Service Modeġ. This article will explain how to enter service mode on your GE washer dryer combo and how to decipher the error codes given by the control. The GE Laundry Center diagnostics service mode is fairly easy to use once you grasp how to use it. GE Laundry Center Diagnostics Service Mode

Ge lid lock broken